JB Kind External Paint Grade Plywood Veneer Flush Fire Door FD30

• Plywood veneered exterior door
• Supplied unfinished
• Solid core construction
• BWF-CERTIFIRE FD30 fire door - 30 minute protection
• Door thickness - 44mm

Technical Information

This door has been given a FD30 rating - meaning it has 30 minutes protection from fire damage. These doors are also thicker (44mm) as opposed to standard rating doors.

Trimming: Door can be trimmed by up to 5 mm on any edge. When trimming doors, reduce them equally and not excessively from top and bottom for height, to the hanging edge only for the width (if minimal) but equally with the meeting edge if a greater amount is necessary. This information does not apply to doors with a FD30 fire rating. 

Storage: When receiving door it should be laid flat fully supported off the floor in a dry and fully ventilated area with protective packaging intact. Doors supplied unfinished should be thoroughly sealed on all faces and edges prior to any installation work. 

Finishers: Be sure to select a finisher with a lasting seal between component parts. Please avoid water based finishers, using only good quality solvent based finishers. Danish oil is not suitable for use on any of our doors.

• Not recommended for use externally where exposed to central heating on the inside.
• It is essential these doors are thoroughly painted prior to exposure to the weather in accordance with our door care advice. Face knots should be sealed prior to painting to prevent resin bleed, which can result where exposed to ultra violet light. Screw or staple holes will need filling prior to decoration.
• Must be installed and sealed in accordance with our "Door Care and Maintenance Advice" which comes supplied with each door.
• It is never advisable or intended that timber external doors be fully exposed to the worst elements of the weather, even if well coated. A southerly or south-westerly elevation is the worst direction for prevailing weather and exposure to the hottest sun can seriously degrade external doors.
• We recommend these are set back from the front face of the building or covered by a canopy.
• Always fit with a suitable weatherboard regardless of frame cill type fitted to prevent droplets of moisture hanging from the door bottom.
• We recommend washing down with warm water and detergent every two to three years and re-coating in order to retain good appearance.